How an Amana wall oven reports a fault
Amana single electric wall ovens use the same control platform as the ranges, so the same F#E# scheme applies — Amana writes the digits F-then-E. These are single, electric, thermal ovens; there is no current Amana double or gas wall oven, so any code list claiming double-oven or gas-oven faults does not apply here. The first step in any Amana oven repair is reading the code, then testing the named part before replacing it.
The codes you will see
F6 E1 means the oven sensed an over-temperature during a cook cycle and shut down for safety, pointing at the RTD sensor, a relay on the control board or the wiring. F9 E0 flags an electrical or miswire fault, most common right after installation — the 240V supply and the junction-box wiring are verified first. F3 E0 (sensor open) and F3 E1 (sensor shorted) mean the oven temperature sensor reads out of range, so baking runs hot or cold. F5 E0 and F5 E1 are door-lock faults that typically follow a Self-Clean Option cycle.
Features that look like faults
Some behaviour is by design, not a fault. The Self-Clean Option locks the Easy-Clean Glass Door until the cavity cools, Sabbath Mode disables tones and lights, and Oven Lockout disables the controls — each can make the oven appear stuck. An F2 E1 keypad-ribbon fault, by contrast, is a genuine fault that makes the Easy Touch Electronic Controls ignore input. Confirming the mode state first avoids replacing a part needlessly.
What to check, and when to call
For a one-off door-lock or over-temp code after self-clean, let the oven cool fully and power-cycle at the breaker for 30 to 60 seconds. For an F9 E0, the supply wiring is checked before the board. A recurring sensor (F3), lock (F5), over-temp (F6 E1) or control fault needs an experienced, independent technician with the correct genuine OEM part. See the oven error codes page or the error codes library, then book oven repair. Confirm your model at amana.com.