What Ld means on your Amana washer (amana ld error)
A amana ld error on an Amana washer means a long-drain condition — the lettered alias of F9 E1, meaning the washer is not draining in time. It usually traces to a clogged filter, a blocked hose, or an object in the pump.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different fault on your Amana washer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a cleaning or self-clean cycle, a spill, or recent installation or service.
- “Ld” shows
- Water remains in the drum after the cycle
- Draining is slow or absent
- The spin will not start until water clears
Common causes
Several different faults can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Amana parts.
- Clogged pump filter — debris blocks the drain
- Blocked or kinked drain hose — water cannot leave
- Object in the pump — a small item jams the impeller
- Failed drain pump — the pump cannot move water
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Check the drain hose for kinks and that the standpipe is clear.
- Clean the pump filter if your model has an accessible one.
- Turn the washer off at the breaker for 30 to 60 seconds, then restore power.
- If it still will not drain, leave the pump for service.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the drain pump, pump filter, drain hose, standpipe, and control board. The correct part for your Amana washer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so that performance, safety, and the appliance’s long working life are all protected. Confirming the failed part before ordering avoids replacing more than the fault actually requires.
When to call a technician
Ld that remains after clearing the filter and hose needs a technician to test the drain pump. When the fix calls for trained service, you can schedule an appointment and an experienced, skilled technician will diagnose and repair it.
As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. This condition is rated Medium severity, so there is no emergency — but if the same Ld keeps returning after the checks above, a technician should confirm the cause before any part is replaced. When you book, have your Amana washer model and serial number ready — they are usually on a label inside the door, behind a drawer, or on the side panel — so the right part for your exact build can be matched before the visit and the Ld condition resolved in as few trips as possible.
Related help and Amana resources
Browse other Amana Washer error-code guides, read about Amana Washer repair, look up your unit in the Amana models reference, or schedule an appointment. Or see the related F9 E1 long drain. For full manufacturer specifications and model lookup, visit the manufacturer at amana.com.
