What F5 E2 means on your Amana washer (amana f5e2 error)
A amana f5e2 error on an Amana washer means a lid-will-not-lock condition — the motorized lid lock did not reach the locked position, so the washer holds the cycle.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different fault on your Amana washer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a cleaning or self-clean cycle, a spill, or recent installation or service.
- “F5 E2” shows
- The lid will not lock to start a spin
- You may hear the lock motor without it seating
- The cycle will not proceed
Common causes
Several different faults can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Amana parts.
- Lid-lock motor timeout — the lock does not reach position
- Obstruction at the lid — something blocks the lock
- Worn lock assembly — the lock no longer engages
- Wiring or control fault — the lock signal is lost
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Make sure nothing blocks the lid and it closes squarely.
- Turn the washer off at the breaker for 30 to 60 seconds, then restore power.
- Try starting a cycle to see whether the lid locks.
- If “F5 E2” persists, leave it for service.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the lid-lock motor, lock assembly, strike, wiring, and control board. The correct part for your Amana washer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so that performance, safety, and the appliance’s long working life are all protected. Confirming the failed part before ordering avoids replacing more than the fault actually requires.
When to call a technician
F5 E2 needs a technician to test the lid-lock motor and the lock assembly and replace the faulty part. When the fix calls for trained service, you can schedule an appointment and an experienced, skilled technician will diagnose and repair it.
As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. This condition is rated Medium severity, so there is no emergency — but if the same F5 E2 keeps returning after the checks above, a technician should confirm the cause before any part is replaced. When you book, have your Amana washer model and serial number ready — they are usually on a label inside the door, behind a drawer, or on the side panel — so the right part for your exact build can be matched before the visit and the F5 E2 condition resolved in as few trips as possible.
Related help and Amana resources
Browse other Amana Washer error-code guides, read about Amana Washer repair, look up your unit in the Amana models reference, or schedule an appointment. Or see the related F5 E3 lid-lock failure. For full manufacturer specifications and model lookup, visit the manufacturer at amana.com.
