What rL means on your Amana washer (amana rl error)
A amana rl error on an Amana washer means a load-detected condition on a front-load washer — the washer sensed laundry in the drum when the empty Clean Washer cycle was started.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different fault on your Amana washer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a cleaning or self-clean cycle, a spill, or recent installation or service.
- “rL” shows during a Clean Washer cycle
- The cycle will not continue
- Laundry is in the drum
- It only appears at the start of the cleaning routine
Common causes
Several different faults can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Amana parts.
- Load left in the drum — the Clean cycle must run empty
- Item not removed — a towel or mat remains inside
- Sensor reading mass — residual weight is detected
- Cycle started by mistake — a Clean cycle was begun with a load
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Remove all laundry from the drum.
- Restart the Clean Washer cycle empty.
- Use only the recommended washer cleaner.
- If “rL” shows with a truly empty drum, leave it for service.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the wash drum, load, clean washer cycle, and control board. The correct part for your Amana washer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so that performance, safety, and the appliance’s long working life are all protected. Confirming the failed part before ordering avoids replacing more than the fault actually requires.
When to call a technician
rL with a genuinely empty drum needs a technician to check the load sensor and control board. When the fix calls for trained service, you can schedule an appointment and an experienced, skilled technician will diagnose and repair it.
As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. This condition is rated Low severity, so there is no emergency — but if the same rL keeps returning after the checks above, a technician should confirm the cause before any part is replaced. When you book, have your Amana washer model and serial number ready — they are usually on a label inside the door, behind a drawer, or on the side panel — so the right part for your exact build can be matched before the visit and the rL condition resolved in as few trips as possible.
Related help and Amana resources
Browse other Amana Washer error-code guides, read about Amana Washer repair, look up your unit in the Amana models reference, or schedule an appointment. Or see the related F0 E1 load during Clean cycle. For full manufacturer specifications and model lookup, visit the manufacturer at amana.com.
