What HC means on your Amana washer (amana hc error)
A amana hc error on an Amana washer means a hoses-reversed condition — the washer detected the hot and cold fill hoses connected to the wrong taps, so water arrives at the wrong temperature.
Symptoms
The signs below help confirm you are dealing with this condition rather than a different fault on your Amana washer. You may notice one of them or several together, and they can appear gradually or suddenly after a power event, a cleaning or self-clean cycle, a spill, or recent installation or service.
- “HC” shows
- Water temperature is the opposite of what is selected
- The code often appears after installation or a move
- Cold washes arrive hot, or vice versa
Common causes
Several different faults can produce these symptoms. Working through the most likely causes in order separates a quick owner-level check from a problem that needs trained service and the correct Amana parts.
- Hoses reversed — hot and cold fill hoses are swapped
- Crossed supply taps — the home plumbing feeds the wrong sides
- Recent install — the hoses were connected the wrong way
- Mixing valve issue — temperature is blending incorrectly
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where mains voltage, gas, a hot oven cavity, water, or a sealed component is involved, and hand the rest to a qualified technician.
- Turn off both supply taps.
- Swap the hot and cold fill hoses so each matches its tap.
- Turn the supplies back on and restart a cycle.
- If “HC” remains with the hoses correct, leave it for service.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the fill hoses, supply taps, and water inlet valve. The correct part for your Amana washer is matched from the model and serial number, and genuine OEM components are fitted through trusted parts suppliers rather than generic substitutes so that performance, safety, and the appliance’s long working life are all protected. Confirming the failed part before ordering avoids replacing more than the fault actually requires.
When to call a technician
HC that remains with correctly connected hoses needs a technician to check the inlet valve and temperature sensing. When the fix calls for trained service, you can schedule an appointment and an experienced, skilled technician will diagnose and repair it.
As an independent repair service we are not affiliated with the manufacturer, and we work only with experienced, skilled technicians and genuine OEM parts from trusted parts suppliers, with our workmanship backed by a 30-day labor warranty. This condition is rated Low severity, so there is no emergency — but if the same HC keeps returning after the checks above, a technician should confirm the cause before any part is replaced. When you book, have your Amana washer model and serial number ready — they are usually on a label inside the door, behind a drawer, or on the side panel — so the right part for your exact build can be matched before the visit and the HC condition resolved in as few trips as possible.
Related help and Amana resources
Browse other Amana Washer error-code guides, read about Amana Washer repair, look up your unit in the Amana models reference, or schedule an appointment. Or see the related F8 E1 long fill. For full manufacturer specifications and model lookup, visit the manufacturer at amana.com.
